Solutie curatare si revigorare aerograf (de smalturi si culori ulei), 125 ml, Zest-it, se foloseste pentru a curata aerograful de culori si cerneluri pe baza de ulei inainte de a se folosi o alta culoare. Adauga o cantitate mica de solutie in recipient (circa 1 ml) si spreyaza prin aerograf pentru a-l curata pe interior. De asemenea, pot curata aerograful si la exterior de reziduurile de vopsea sau cerneala uscata sau il poti scufunda in solutie pentru 10 min. Foloseste manusi daca ai pielea sensibila. Nu spreya spre fata sau corp. Produs in UK.
Zest-it� Airbrush Cleaner and Reviver (for Enamels and oil based media). Use Zest-it Airbrush Cleaner and Reviver to clean your Airbrush between colour changes. Add a small amount of Zest-it Airbrush Cleaner and Reviver to your cup or bottle, spray through your airbrush, before adding new colour. Zest-it Airbrush Cleaner and Reviver can also be used to bath your Airbrush in to remove all dried on ink or paint. Use enough to cover your disassembled airbrush and leave to soak for 10+ minutes. Wear Nitrile gloves if skin is sensitive and use eye protection if splashes are likely. Do not spray towards body or face. Suitable for Oil based inks and paints.
When a colour change is necessary whilst working, place just a few drops (roughly 1 ml) into the paint cup of the Airbrush and spray into a 'cleaning pot' and spray through until clear. Pour out the remaining liquid from cup or wipe dry with kitchen towel, add new colour and test on scrap paper. If the Airbrush is clogged, disconnect from the airline, place in suitable shallow sided container and add Airbrush Cleaner and Reviver to cover. Allow to soak for about 10 minutes, further soaking may be necessary depending on the paint/ink. The parts may feel slippery to the touch, so it is best to use Nitrile gloves for grip and hand protection or a bowl of soapy water and hand-towel to clean and dry your hands as you work. You may otherwise find the small parts of the airbrush slipping out of your grip. Also working with a paper cloth or towel helps. Working with a paper cloth or a towel also helps. Most enamel, oil paint and ink products can be cleaned and released from the airbrush after a 10 minute soak. Different products may require a longer soak. Using water through the airbrush is not recommended when using oils based media. The Reviver can be re-used by allowing to stand and then filtered (using cloth or paper) into a clean container. Label and store the used Zest-it Airbrush Reviver for re-use. Note: If you wish to use water based media in an Airbrush that has been used for oils, it is recommend to use the Airbrush Cleaner for Acrylics or Zest-it Washaway for cleaning the brush. If not cleaned in this way the products can emulsify in the brush causing spitting or bubbling. Safety note: When spraying through the airbrush point away from the body and face; do not breathe the spray; have adequate ventilation; wash hands frequently; promptly wipe up spills as the surface will be slippy; wear Nitrile gloves if skin is sensitive; eye protection if splashes are likely.
Nota: Imaginea de produs prezentata are caracter informativ si nu reprezinta obligatie contractuala. Pot exista diferente intre aceasta si produsul respectiv, precum variatiuni de nuante in functie de rezolutia ecranului dispozitivului dvs. cu care ati accesat aceasta pagina.
Descrierea produsului este cu titlu pur informativ, asa cum a fost preluata din site-ul furnizorului. Pentru informatii precise si actualizate, consultati siteul firmei producatoare.